IPv6 Autoconfig page - multiple groups

Post Reply
robhorton
Posts: 3
Joined: Sat Sep 06, 2014 10:40 am

IPv6 Autoconfig page - multiple groups

Post by robhorton »

Hi,

I have two LAN Interface groups defined (Default and WiFi) and have managed to assign different IPv4 address to each of them. When I go to the "IPv6 autoconfig" section however, only the "Default" option appears in the drop down list - I would expect both to appear (as in the Ethernet page). Is this normal or have I missed some other setting (The config works fine for the Default group)? Is there some other way of doing this?

Thanks,
Rob
billion_fan
Posts: 5374
Joined: Tue Jul 19, 2011 4:30 pm

Re: IPv6 Autoconfig page - multiple groups

Post by billion_fan »

robhorton wrote:Hi,

I have two LAN Interface groups defined (Default and WiFi) and have managed to assign different IPv4 address to each of them. When I go to the "IPv6 autoconfig" section however, only the "Default" option appears in the drop down list - I would expect both to appear (as in the Ethernet page). Is this normal or have I missed some other setting (The config works fine for the Default group)? Is there some other way of doing this?

Thanks,
Rob
I'll check with our engineers and get back to you :D
robhorton
Posts: 3
Joined: Sat Sep 06, 2014 10:40 am

Re: IPv6 Autoconfig page - multiple groups

Post by robhorton »

Did you get anywhere with this?

Rob
billion_fan
Posts: 5374
Joined: Tue Jul 19, 2011 4:30 pm

Re: IPv6 Autoconfig page - multiple groups

Post by billion_fan »

robhorton wrote:Did you get anywhere with this?

Rob
I haven't had a update on this, so I have re-submitted the issue

I'll keep you posted :D
billion_fan
Posts: 5374
Joined: Tue Jul 19, 2011 4:30 pm

Re: IPv6 Autoconfig page - multiple groups

Post by billion_fan »

billion_fan wrote:
robhorton wrote:Did you get anywhere with this?

Rob
I haven't had a update on this, so I have re-submitted the issue

I'll keep you posted :D
After checking with our engineers they have stated the "IPv6 Autoconfig" only supports the br0 interface which is "Default".
Post Reply